cbr125 forum https://www.cbr125world.com/forum/ |
|
hi from blighty... https://www.cbr125world.com/forum/viewtopic.php?f=21&t=270 |
Page 1 of 1 |
Author: | Gotany911 [ Sun Apr 09, 2017 11:47 am ] | |||
Post subject: | hi from blighty... | |||
thought i would share a couple of pictures of my bike, looking so forward to getting my kit from you guys, the bike was a stolen recovered and it had all the fairings but in different colours (color for the usa) and been chucked down the roads a couple of times by the captain choas who nicked it and was trying to get away from the rozzers(police). I put a dan moto exsaust on it the baffle they supplied was not enough to quiet it down enough so i made one up from a washing machine drum and and kept drilling the holes out till i was happy with the sound. put a avon roadrunner back tyre on which keeps a smile going while i scrub in the tyre and slowly getting nearer to the edge. got a gecko kevlar clutch and plates toput on with your springs, put a simota air filter on, a lot cheaper than K&N( i agree with marvin i dont think you can beat the OEM filter) but thought i would give this other filter a go. The fairings i covered in vinyl wrap, lots of praticing and burnt fingers, but paid a bit more for quality vinyl and it is worth the it as you can take it off and try again. I use castrol fully syn 10/30 oil and wow what a buzz it is using it,somuch smoother. i got a slinky set of seals for the forks so will do that as well while putting the clutch togeather. you guys are doing a fantasic job thanks for pointing me in the right direction and every thing you do makes perfect sense. leon i put the pictures on but the after shot went upside down the picture i put on was the right way...
|
Author: | Gotany911 [ Sat May 20, 2017 4:19 am ] | ||
Post subject: | Re: hi from blighty... | ||
Hi again put new chain on plus your kit and it's perfect now, I will put a scannned template of the gasket for right side, be easier to buy gasket paper stick it in a printer and print it, i use hole punch for the bolt holes after i have cut outer edge i customise a hole punch so i can see where the hole is. its here if anybody wrecks there old one...
|
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |