cbr125 forum
https://www.cbr125world.com/forum/

CBR125 Valve clearance inspection
https://www.cbr125world.com/forum/viewtopic.php?f=18&t=105
Page 1 of 1

Author:  zooman001 [ Thu Sep 25, 2014 5:49 pm ]
Post subject:  CBR125 Valve clearance inspection

As per the owners manual on my 2008 cbr 125, valve clearance should be checked every 4000km. Is this excessive? Is it hard to do? Thanks

Author:  mmiller [ Fri Sep 26, 2014 8:54 am ]
Post subject:  Re: Valve clearance inspection

It's a bit of a pill the first time through. Once you do it once or twice it's not that bad. In fact, I'll be doing it again shortly as it's that time.

Experience has shown that the first valve lash is very important. This is because the camshaft and valvetrain break-in together and there is some wear. Once the first valve lash has been done it's much less critical as the majority of the wear has already occurred.

Easiest way is to remove both front side covers and the radiator. Once they are out of the way it's not too bad :top: Lifting the tank also makes it easier.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/